从6-APA和7-ADCA生产废液中回收苯乙酸

采用溶剂萃取、水法提取等方法从6-氨基青霉烷酸和7-氨基-3-去乙酰氧基头孢烷酸生产废液（简称废液）中回收苯乙酸（PAA）,考察了各种因素对回收效果的影响。实验结果表明：以甲苯为萃取剂,在萃取温度30℃、萃取时间15m in、500mL废液中萃取剂加入量130mL的最佳条件下,萃取率为96.5%;在提取温度为65℃左右、结晶温度低于10℃的条件下,PAA收率大于89%,纯度大于99%;所得PAA产品质量好,可用于青霉素G等医药产品的生产。     

钠盐量影响下DD6单晶高温合金的高温热腐蚀规律研究

目的 开展镍基单晶高温合金DD6在950 ℃下的热盐腐蚀试验(95%Na2SO4+5%NaCl)，探明涂盐量和涂盐方式(周期涂盐和单次涂盐)对DD6高温热腐蚀的影响规律和机理。方法 结合扫描电子显微镜、X射线能量色散谱、X射线衍射等设备，对不同涂盐量及涂盐方式下DD6的表面及横截面形貌进行观察分析，分析不同涂盐量和涂盐方式下DD6的高温热腐蚀机理。结果 DD6在950 ℃下主要发生碱性熔融热腐蚀，同时伴随氧化、硫化和氯化等过程。高温热腐蚀使得DD6合金表面生成的保护性氧化膜被熔融态的腐蚀介质破坏，导致O、S、Cl等外部元素通过氧化膜的缺陷进入DD6基体中，在合金的亚表面发生内氧化、内硫化以及内氯化反应，横截面上出现明显的腐蚀层，其主要由氧化物以及硫化物组成。随着热腐蚀的进行，DD6表面物质发生了剥蚀，沉积盐量的增加导致剥蚀现象越加严重，合金内部致密的组织结构也被破坏，横截面上出现了大量孔洞、裂纹等缺陷。在相同涂盐量下，周期涂盐法使得DD6的腐蚀程度高于单次涂盐法。结论 DD6高温热腐蚀行为与涂盐量及涂盐方式密切相关，相同涂盐方式下，涂盐量越大，DD6热腐蚀更加严重。涂盐量一定时，周期涂盐法使得DD6的热腐蚀剧烈程度大于单次涂盐法，且DD6在上述热腐蚀条件下均发生剥蚀破坏。     

Bi2MoO6/纳米棒ZnO异质结对MB的可见光-压电协同降解性能研究

采用水热法合成了一系列不同负载率的Bi₂MoO₆/纳米棒ZnO复合光催化剂.通过XRD、FT-IR、SEM、TEM、XPS、UV-Vis、EPR和PL等分析技术对合成的样品进行表征.在光/超声波条件下,以亚甲基蓝（MB）为目标降解物评价其压电-光催化性能.结果表明：Bi₂MoO₆/ZnO纳米棒（BZ-0.6）的降解速率常数约为ZnO传统光催化的9.25倍,其性能提升的主要原因在于ZnO的压电效应与Bi₂MoO₆/ZnO界面形成的异质结的耦合,有效地促进了电子和空穴的分离和转移.此外,同实验条件下,循环利用5次后Bi₂MoO₆/ZnO复合光催化剂降解率仍保持良好的稳定性.     

多尺度分割与特征优选下的盐碱地提取

土地盐渍化作为一种土壤灾害,严重制约着社会经济与农业的发展。对盐碱地进行实时监测,可为盐碱地的评价改良提供科学依据。由于盐碱地的信息复杂、提取精度不高,因此本文以高分六号（GF-6）卫星遥感影像为数据源,采用分形网络演化算法（fractal net evolution approach,FNEA）进行影像对象的多尺度分割,从面向对象的角度减少高分影像分类结果中的椒盐噪声问题,通过计算图像对象的局部方差和变化率来确定适宜的盐碱地分割尺度。利用基于特征选择的相关性算法（correlations-based feature selection,CFS）与Relief F算法分别对由光谱、纹理、形状、遥感指数构成的初始特征空间进行特征优选,精简特征子集,解决特征数量冗余问题,以此来优化随机森林对盐碱地提取精度。结果表明：CFS约简后的特征子集更小,精度更高,说明在盐碱地提取过程中,筛选特征数目能够减小冗余数据对提取精度的影响。CFS优化后的随机森林对盐碱地的提取效果较好,该方法总体分类精度达到83.7%。     

Changes in TcpA gene frequency explain 2,4,6-trichlorophenol degradation in mesocosms

Soils are often polluted by chlorophenols in timber production areas in the northern hemisphere. The tcpA gene encodes the first step of 2,4,6-trichlorophenol (246-TCP) degradation. We tested tcpA gene frequency in three natural pristine soils with different 246-TCP degradation capacity. Gene tcpA frequency increased more in spiked than non-spiked 10-L pails containing coniferous humus soil with high degradation capacity, in contrast to soils where degradation was slower. As the soil in each mesocosm originated from a spatially separate field plot, changes in tcpA gene frequency affected 246-TCP degradation over a range of soil origins. This indicates that the abundance of and changes in tcpA gene frequency could be utilized in estimating the efficacy of natural attenuation and biostimulation treatments in controlled conditions.     

工业废水中测定六价铬的预处理技术

根据复合絮凝剂与阳离子交换树脂两者在分离与处理技术上所起的不同作用 ,提出了将两法联合用作工业废水中测定Cr6 的预处理技术 ,通过一系列条件试验 ,确定最佳预处理条件。结果表明 ,该法具有去色、去浊率高 ,分离效果佳 ,排除干扰离子能力强 ,分析样品重现性好 ,准确度高 ,操作简便、快捷的优点。     

Development and application of LC–APCI–MS method for biomonitoring of animal and human exposure to imidacloprid

Imidacloprid (IMI) is a relatively new neuro-active neonicotinoid insecticide and nowadays one of the largest selling insecticides worldwide. In the present study a LC–APCI–MS based method was developed and validated for the quantification of imidacloprid and its main metabolite 6-chloronicotinic acid (6-CINA) in urine and hair specimens. The method was tested in biomonitoring of intentionally exposed animals and subsequently applied for biomonitoring of Cretan urban and rural population.     

Fe^3＋掺杂TiO2/凹凸棒复合材料的光催化性能

采用酸催化的溶胶-凝胶法制备了一系列Fe^3＋掺杂TiO2/凹凸棒（Fe^3＋-TiO2/ATP）复合光催化剂材料。在可见光条件下,以亚甲基蓝（MB）溶液的光催化降解反应,评价了样品的光催化性能,研究了TiO2负载量、Fe^3＋掺杂量和焙烧温度对复合材料光催化性能的影响。在单因素实验的基础上,采用正交实验设计（L25（53））优化了催化剂的制备条件。光催化实验结果表明,MB在复合材料上的光催化降解反应遵循Langmuir-Hinshelwood（L-H）动力学模型。正交实验结果表明,当TiO2负载量为15%、Fe^3＋掺杂量为0.5%和焙烧温度为550℃时,得到的复合材料对MB的光催化降解效率最佳,测得表观反应速率常数kapp为6.09×10^-3min^-1,反应4 h后MB的降解率（Dt）可达75.88%,相同实验条件下与P25（1.51×10^-3min^-1）相比较,反应速率提高了4.03倍,降解率提高了45.05%。另外,复合材料的沉降性能优于P25,易于分离,是一类有应用前景的复合光催化剂。敏世雄王芳魏立强王永生冯雷佟永纯韩玉琦     

Degassing of H/He, CFCs and SF6 by denitrification: Measurements and two-phase transport simulations

The production of N₂ gas by denitrification may lead to the appearance of a gas phase below the water table prohibiting the conservative transport of tracer gases required for groundwater dating. We used a two-phase flow and transport model (STOMP) to study the reliability of ³H/³He, CFCs and SF₆ as groundwater age tracers under agricultural land where denitrification causes degassing. We were able to reproduce the amount of degassing (R² = 69%), as well as the ³H (R² = 79%) and ³He (R² = 76%) concentrations observed in a ³H/³He data set using simple 2D models. We found that the TDG correction of the ³H/³He age overestimated the control ³He/³He age by 2.1 years, due to the accumulation of ³He in the gas phase. The total uncertainty of degassed ³H/³He ages of 6 years (± 2 σ) is due to the correction of degassed ³He using the TDG method, but also due to the travel time in the unsaturated zone and the diffusion of bomb peak ³He. CFCs appear to be subject to significant degradation in anoxic groundwater and SF₆ is highly susceptible to degassing. We conclude that ³H/³He is the most reliable method to date degassed groundwater and that two-phase flow models such as STOMP are useful tools to assist in the interpretation of degassed groundwater age tracer data.     

亚超临界水技术在废旧尼龙6解聚中的应用

研究了尼龙6在亚超临界水中的解聚反应,以期为废旧尼龙6的回收利用提供技术参数.实验分别利用气质联用仪和紫外分光光度计对解聚后的液相产物进行定性和定量分析,并考察了不同的反应温度、反应压力和反应时间对液相产物收率的影响.结果表明,液相产物绝大部分为己内酰胺;解聚的最佳条件为370 ℃、25 MPa、60 min;己内酰胺最大收率为96%.通过动力学分析和Arrhenius关系计算,得出尼龙6亚超临界水解聚的活化能为64.4 kJ/mol.